When using this Chromebox, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following:
- Do not place the device on an uneven or unstable surface.
- Do not use this device near water.
- Do not spill water or other liquids into or on the device.
- The device may produce some heat during normal operation. If you feel the device is too warm, avoid sustained contact with exposed skin otherwise this might cause discomfort, or eventually a burn.
- Clean only with a soft cloth. If needed, dampen the cloth slightly before cleaning. Never use abrasives or cleaning solutions.
- Always disconnect the device from an electrical outlet and power off before cleaning the device.
- Refer all servicing to qualified service personnel. Servicing is required when the device has been damaged in any way such as:
- Docking connector is damaged.
- Liquid has been spilled into the device.
- The device has been exposed to rain or moisture.
- The device does not operate normally.
- The device was dropped or the chassis is damaged.
Engineering Conditions of Acceptability
- The following end-product enclosures are required: Fire
- The end product should evaluate all likely positions of the equipment’s orientation during installation and take opening requirements into account.
Battery notices
The terms HDMI, HDMI High-Definition Multimedia Interface, HDMI Trade Dress and the HDMI Logos are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Important
- Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
- Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas.
- A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.
Products incorporating button or coin cell batteries
Instructions and manuals, if provided, shall include all of the applicable markings in figures “Packing marking - Warning: Contains coin battery” or “Packing marking - Warning of ingestion hazard” and the statements noted below. If instructions and manuals are not provided, the statements shall be present on the principal display panel or secondary display panel of the consumer product packaging, or if there is no consumer product packaging, the accompanying hang tag or sticker label.
a) The statement “Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate.”
b) The statement “Even used batteries may cause severe injury or death.”
c) The statement “Call a local poison control center for treatment information.”
d) A statement indicating the compatible battery type ML1220.
e) The nominal battery voltage is 3V.
f) The statement “Non-rechargeable batteries are not to be recharged.”
g) The statement “Do not force discharge, recharge, disassemble, heat above (manufacturer’s specified temperature rating) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.”
Packing marking - Warning: Contains coin battery
Packing marking - Warning of ingestion hazard
The product contains non-replaceable button/coin cell battery ML1220.