Can I control the BenQ projector with a remote control designed by other manufacturers?
Yes. When setting the remote control, please input the [custom code + IR code] or [IR code + custom code] based on the instruction on the remote control.
The custom code for BenQ is 0X30. For IR code, please refer to the user manual.
Which reminder messages will stop being displayed after "Reminder Message" is switched off?
After "Reminder Message" option is switched off in OSD, the following messages will stop being displayed:
- All signal searching…
- No signal
- (Source) Source searching…
- (Source) Source detected
- Auto adjusting…
- Signal status(Source information menu)
- ECO BLANK/No source detected
- Out of range
- Best resolution
I forgot the password, is there any way to unlock the projector?
Due to security concern, it is designed as not possible to unlock the projector if the password is forgotten. The only way is to return the projector to service center for resetting.
Why is the projector locked (lamp LED is flashing in red and could not be lit up)?
The projector will be locked when the lamp hour reaches 2,500 hours. It is a protection mechanism in case lamp shatters over 2,500 hours. Projector will be unlocked after replacing lamp and resetting lamp hour.
How do I clean my projector lens?
Please refer to the below video for a guide to cleaning your projector's lens.
How do I mute the projector?
The projector can be muted using one of the following settings -
1. OSD > System setup > audio settings > mute
2.. Mute key on remote
The mute function will reset to default (Off) when the projector is restarted, which means audio will be on.
Therefore, if you wish to mute the projector permanently, please turn the audio volume down to 0. Volume levels do not reset for power cycles or restarts.