Can I control the BenQ projector with a remote control designed by other manufacturers?
Yes. When setting the remote control, please input the [custom code + IR code] or [IR code + custom code] based on the instruction on the remote control.
The custom code for BenQ is 0X30. For IR code, please refer to the user manual.
Which reminder messages will stop being displayed after "Reminder Message" is switched off?
After "Reminder Message" option is switched off in OSD, the following messages will stop being displayed:
- All signal searching…
- No signal
- (Source) Source searching…
- (Source) Source detected
- Auto adjusting…
- Signal status(Source information menu)
- ECO BLANK/No source detected
- Out of range
- Best resolution
Could I connect my iPhone to MHL port of projector to project documents, photos, videos and any other contents in iPhone to screen by mirroring?
iPhone does not support MHL. Nevertheless, Our projector combines MHL & HDMI in the same port. You still could project the contents in iPhone via HDMI without problem.
Why is 3D greyed out in picture mode?
3D mode is appropriate for playing 3D images and 3D video clips. The mode only shows when 3D content is detected. In other words, when 3D is on, picture modes only shows 3D. When 3D is off, 3D is greyed out and not shown in picture mode.
How do I clean my projector lens?
Please refer to the below video for a guide to cleaning your projector's lens.
How to change the lamp and reset the lamp timer?
Please refer to the below video for instructions on how to replace a projector lamp and reset the lamp life timer on BenQ projectors.
How do I mute the projector?
The projector can be muted using one of the following settings -
1. OSD > System setup > audio settings > mute
2.. Mute key on remote
The mute function will reset to default (Off) when the projector is restarted, which means audio will be on.
Therefore, if you wish to mute the projector permanently, please turn the audio volume down to 0. Volume levels do not reset for power cycles or restarts.